remmington
Apprentice
Owns Spark Eroder
Posts: 4,966
Member is Online
|
Post by remmington on Mar 10, 2023 8:15:45 GMT 1
www.welzh.com/products/pullers/Watch video on link. ----------- I like the idea of this - @£450 it is a bit spendy thou. Gonna look about for some scrap to make one. 9kg slide hammer - I got the spec' off eBay.
|
|
|
Post by Joepublic on Mar 10, 2023 9:47:51 GMT 1
Edited out
|
|
|
Post by liam99 on Mar 13, 2023 23:52:20 GMT 1
I've got similar one from Sudorf, Great bit of kit. Some of smaller arms like micra's it can bend them. Don't remember it being that much
|
|
|
Post by OldGit on Mar 14, 2023 8:08:15 GMT 1
Also remember that a lot of the alloy lower arms have weak points designed in, it'd be very easy to distort or even fracture one without noticing.
|
|
|
Post by chippie on Mar 14, 2023 14:48:38 GMT 1
Never had to resort to using any kind of puller for ball joints or track rod ends… Just use two hammers…..
|
|
|
Post by Karl on Mar 15, 2023 0:34:32 GMT 1
|
|
|
Post by Karl on Mar 15, 2023 0:52:51 GMT 1
I can confirm it’s a monster
Pops ball joints out like there nothing
Accidentally pulled a transit ball joint out with one
Like said just be careful
|
|
|
Post by rhyds on Mar 15, 2023 12:31:18 GMT 1
I can confirm it’s a monster Pops ball joints out like there nothing Accidentally pulled a transit ball joint out with one Like said just be careful Good Lord that's a big 'un! (said the actress to the bishop)
|
|
|
Post by Rhubarb on Mar 16, 2023 9:32:26 GMT 1
I think these are best suited for commercial vehicle use. Would certainly do more harm than good if not careful using on a car.
|
|