|
Post by wheelnut on Feb 28, 2013 20:49:45 GMT 1
It's the dreaded 307HDi again! I changed the oil today, parked on level ground and gave it the final check with the dip stick. Well not quite, when I pulled out the dip stick about two inches had broken off the end and is now somewhere in the sump. It broke just at the "full" mark.
It's a plastic dip stick so presumably it had become brittle with old age. I know it will not go through the strainer on the pick-up of the oil pump so I'm wondering is it safe to leave it where it is. Is there anything else it could get caught in such as a chain driven oil pump? Would it come out with the next oil change?
The car is a 2004 model with 150k miles on the clock so it's not worth very much. I don't think I could justify the cost of opening up the engine just to remove a piece of plastic.
|
|
french crap fanatic
Apprentice
french car specialist based in dagenham east london
Posts: 3,355
|
Post by french crap fanatic on Feb 28, 2013 20:55:32 GMT 1
ive seen loads of cars over the years break their dipsticks. never known it to cause an issue. never seen the broke end come out in the oil either. oh btw i found one good thing about the 307. the heater matrix is a doddle to change!!!
|
|
oli
Apprentice
Posts: 1,065
|
Post by oli on Feb 28, 2013 22:53:06 GMT 1
What possible benefit can there be in making a dipstick out of plastic? Surely a case of fixing something that isn't broke - what's wrong with a bendy piece of steel?
|
|
|
Post by rhyds on Mar 1, 2013 0:57:44 GMT 1
What possible benefit can there be in making a dipstick out of plastic? Surely a case of fixing something that isn't broke - what's wrong with a bendy piece of steel? Cost.
|
|