|
Post by Rhubarb on Sept 14, 2015 22:35:12 GMT 1
Hi all, Anyone done a Adaptation on a SMG gearbox? If so what software is required? Been reading about it tonight and wonder if my Launch will do it? Already changed the gearoil, M3 year 2003, the thing performs without fault, but keeps bringing the light on and logging a code for adaptation. If it was a dog I'd shoot it
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 16, 2015 0:38:52 GMT 1
dtc's , should do trans adaptions with that, not sure on the seq clutch though ,
|
|
|
Post by Rhubarb on Sept 16, 2015 8:32:03 GMT 1
dtc's , should do trans adaptions with that, not sure on the seq clutch though , I will get back into it and have a good hunt on the Launch This thing drives so well, the only thing I can think of is because he doesn't use it a lot, the battery voltage getting low could be causing this?!
|
|
|
Post by Rhubarb on Sept 17, 2015 19:05:49 GMT 1
Well, thought I'd cracked this one today!
Launch wouldn't do an adaptation..
I had a close look at the wiring up and around the gearbox and found a rotten wire..Cut a section out and soldered it..
On the ramp it behaved, key on and off a few times..
Back on the floor the light comes on again..
Got the Texa on it, that had an adaptation reset for the gearbox, it seemed to work..
Took it for a 15 mile drive, all good...
Got back turned it on and off again, all good..
Next time the light was on again..
This time unknown error, code 58 which relates to canbus to gearbox ecu..
I think she's got some more wiring issues..Drives perfect though!
Taking it to someone else with who's got a couple of scanners for a fresh look next week.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 17, 2015 19:17:30 GMT 1
Surprised with the launch it doesnt do transmission reset for beemers, is it just not covered for this synch clutch gearbox ? could be a software issue with it setting like that , normally dont see a gear and cant adapt.
|
|
|
Post by Rhubarb on Sept 17, 2015 19:27:00 GMT 1
Surprised with the launch it doesnt do transmission reset for beemers, is it just not covered for this synch clutch gearbox ? could be a software issue with it setting like that , normally dont see a gear and cant adapt. I'm surprised too, but it's 4 odd years old now and I've run out of updates, but saying that the car is a 2003, so it should do it. I've not tried it on an normal auto, I will plug it into my 7 series when I get a chance
|
|
remmington
Apprentice
Owns Spark Eroder
Posts: 4,965
Member is Online
|
Post by remmington on Sept 17, 2015 20:03:53 GMT 1
Mechatronic gearboxes. You gotta love them!
I would go with wiring....
|
|