|
Post by matt2223 on May 1, 2016 7:34:02 GMT 1
Hi guys. Just done a head gasket on a 98 1.2 punto. Tried to start it and it turns over then stops turning before trying to turn again. Any ideas?
|
|
|
Post by rhyds on May 1, 2016 7:46:45 GMT 1
Cam timing?
|
|
|
Post by matt2223 on May 1, 2016 8:43:00 GMT 1
I've lost count the amount of times I've checked it. It was out to start off with but certainly isn't now
|
|
|
Post by rhyds on May 1, 2016 8:48:44 GMT 1
OK, by " Tried to start it and it turns over then stops turning before trying to turn again" what do you mean?
Does the engine try and spin, give a cough then start spinning again?
Are you sure the HT leads are in the right order?
|
|
|
Post by matt2223 on May 1, 2016 9:05:05 GMT 1
Yeah it turns over then almost like its locking up before continuing to turn over again. Leads are all correct. Marked them up before taking apart
|
|
|
Post by rhyds on May 1, 2016 9:10:28 GMT 1
Have you tried turning it over on a bar to see if its going tight (possibly a bent valve or something)?
|
|
|
Post by matt2223 on May 1, 2016 9:11:15 GMT 1
Yeah it turns over then almost like its locking up before continuing to turn over again. Leads are all correct. Marked them up before taking apart
|
|
|
Post by matt2223 on May 1, 2016 9:12:51 GMT 1
Turned it over by hand and doesn't go tight. You can feel the compression as you would normally. On the fiat lump they shouldn't hit anyway or I've never had one hit before when belts have gone
|
|
|
Post by studabear on May 1, 2016 9:33:10 GMT 1
Fluid finding it's way into a cylinder and hydraulic locking?
|
|
|
Post by mayfly on May 1, 2016 9:38:27 GMT 1
Take plugs out and see if it spins freely, if yes then go back to timing.
|
|
|
Post by Karl on May 1, 2016 9:43:10 GMT 1
1998 punto ! Didn't think there where any left
|
|
|
Post by Karl on May 1, 2016 9:46:41 GMT 1
|
|
|
Post by matt2223 on May 1, 2016 9:58:13 GMT 1
I'll have to give it a try. Has anyone had a valve bend on one of these engines? £40 bargain you can't complain
|
|
|
Post by Karl on May 1, 2016 10:14:32 GMT 1
What's the history ? Did you get it as a non runner
|
|
|
Post by matt2223 on May 1, 2016 11:38:01 GMT 1
Got it as it had a misfire to start with but when collected it wouldn't start. Head gasket had blown between 1&2 cylinder so it had a lack of compression
|
|