|
Post by mayfly on Jun 10, 2015 15:28:25 GMT 1
Hi. Ive got this 2004 partner diesel non turbo, the eml is on and when I scanned it I got [ 1, 2c, 16, 87 ] it says refer to technical manual but I dont have anything on these. Any help appreciated. By the way it starts and runs fine ,no issues.Cheers
|
|
french crap fanatic
Apprentice
french car specialist based in dagenham east london
Posts: 3,355
|
Post by french crap fanatic on Jun 10, 2015 18:17:36 GMT 1
Hi. Ive got this 2004 partner diesel non turbo, the eml is on and when I scanned it I got [ 1, 2c, 16, 87 ] it says refer to technical manual but I dont have anything on these. Any help appreciated. By the way it starts and runs fine ,no issues.Cheers Were they current or historic codes? Is vehicle running ok?why were you scanning it? What system did it say was fitted to the car?
|
|
|
Post by jmac200t on Jun 11, 2015 2:31:37 GMT 1
1--general electrical failure 2c-- not listed 16--circuit voltage below threshold 87--missing message There is 2a 2b & 2f. 2a--signal stuck in range 2b--signal cross coupled 2f--signal eratic.
|
|
|
Post by upkeep on Jun 11, 2015 12:26:05 GMT 1
What diagnostic tool used?
|
|
|
Post by mayfly on Jun 11, 2015 14:28:59 GMT 1
ONLY SCANNED BECAUSE ELM WAS ON WHEN IT CAME IN FOR SERVICE,as I said there are no running issues but codes wont clear. I scanned it with Launch. cheers
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 19, 2015 12:42:35 GMT 1
Hi. Ive got this 2004 partner diesel non turbo, the eml is on and when I scanned it I got [ 1, 2c, 16, 87 ] it says refer to technical manual but I dont have anything on these. Any help appreciated. By the way it starts and runs fine ,no issues.Cheers Thems funny codes ! can you put the light out the dodgy car seller way ..
|
|
|
Post by Trevor on Jun 20, 2015 0:57:32 GMT 1
That scan tool! What make is it?
|
|
|
Post by mayfly on Jun 21, 2015 11:40:03 GMT 1
As said I used Launch x431 scanner. Customer is not bothered about light as van is running fine. I just wondered if anyone had any ideas as to what might be causing the problem.
|
|
|
Post by Rhubarb on Jun 21, 2015 19:10:12 GMT 1
As said I used Launch x431 scanner. Customer is not bothered about light as van is running fine. I just wondered if anyone had any ideas as to what might be causing the problem. Try reading again, but by using OBD on the Launch..I had this once with a Renault derv
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 21, 2015 21:50:23 GMT 1
As said I used Launch x431 scanner. Customer is not bothered about light as van is running fine. I just wondered if anyone had any ideas as to what might be causing the problem. Try reading again, but by using OBD on the Launch..I had this once with a Renault derv It may not be eobd on that Rhub, pp is needed . and his code numbers may be missread too.
|
|
|
Post by Rhubarb on Jun 21, 2015 22:15:22 GMT 1
Try reading again, but by using OBD on the Launch..I had this once with a Renault derv It may not be eobd on that Rhub, pp is needed . and his code numbers may be missread too. I know I know, but it may be worth a go..I had a Renault Master mongrel with a Trafic/Vivaro engine, I went in this way to confirm a fubared EGR
|
|
|
Post by mayfly on Jun 23, 2015 18:14:00 GMT 1
Cheers, when it's in again I'll give it a try.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 2, 2015 15:55:21 GMT 1
Cheers, when it's in again I'll give it a try. No give it a Launch
|
|
|
Post by mayfly on Jul 2, 2015 22:22:07 GMT 1
Give it a rest
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 3, 2015 22:09:02 GMT 1
|
|